4-4 Installing Hardware Options
6.Slide the side cover toward the rear of the unit about 1 inch (2.5 cm); then remove the cover.
NOTE: When you remove the access panel, the interlock switch removes power from the system.
Figure 4-1. Removing the server cover
Accessing the Processor
NOTE: To allow easier access, you can tilt the server on the right side (side opposite the removed panel). Be sure to lock the casters if you do tilt the server. The following figures show the server in the tilted or rack model orientation.
1.If adding a processor board, you must remove a terminator board in the processor slot as shown in Figure
NOTE: The terminator board is in place for bus termination reasons and should not be removed except to replace it with a processor board.
