Dell 1950 owner manual E1810 HDD ## Fault, E1812 HDD ## Removed, E1913 CPU & Firmware, Mismatch

Table 1-7. LCD Status Messages (continued)

Code	Text	Causes	Corrective Actions
E1810	HDD ## Fault	The SAS subsystem has	See "Troubleshooting a Hard
		determined that hard drive ##	Drive" on page 104.
		has experienced a fault.

E1811 HDD ## Rbld Abrt The specified hard drive has experienced a rebuild abort.

See "Troubleshooting a Hard Drive" on page 104. If the problem persists, see your RAID documentation.

E1812	HDD ## Removed	The specified hard drive has been Information only.
		removed from the system.

E1913	CPU & Firmware	The BMC firmware does not
	Mismatch	support the CPU.

Update to the latest BMC firmware. See the BMC User’s Guide for more information on setup and use of BMC.

E1A14 SAS Cable A SAS cable A is missing or bad.

Reseat the cable. If the problem persists, replace the cable. See "SAS Controller Daughter Card" on page 56.

E1A15 SAS Cable B SAS cable B is missing or bad.

Reseat the cable. If the problem persists, replace the cable. See "SAS Controller Daughter Card" on page 56.

E1A17	Pwr Cable FB	Flex bay power cable is missing or
		bad.

Reseat the cable. If the problem persists, replace the cable. See "SAS Controller Daughter Card" on page 56.

E1A18	PDB Ctrl Cable	Flex bay control signals cable is
		missing or bad.

Reseat the cable. If the problem persists, replace the cable. See "SAS Controller Daughter Card" on page 56.

E2010	No Memory	No memory is installed in the	Install memory. See "Installing
		system.	Memory Modules" on page 65.
E2011	Mem Config Err	Memory detected, but is not	See "Troubleshooting System
		configurable. Error detected	Memory" on page 102.
		during memory configuration.
E2012	Unusable Memory	Memory is configured, but not	See "Troubleshooting System
		usable. Memory subsystem	Memory" on page 102.
		failure.
E2013	Shadow BIOS Fail	The system BIOS failed to copy	See "Troubleshooting System
		its flash image into memory.	Memory" on page 102.

About Your System

21