
Table
Message | Causes | Corrective Actions |
|
|
|
No boot sector on hard | Incorrect configuration settings in | Check the |
drive | System Setup program, or no | settings in the System Setup program. |
| operating system on hard drive. | See "Using the System Setup Program" |
|
| on page 33. If necessary, install the |
|
| operating system on your hard drive. See |
|
| your operating system documentation. |
|
|
|
No timer tick interrupt | Faulty system board. | See “"Getting Help" on page 125." |
|
|
|
Northbound merge error - | The specified DIMM was unable to | See "Troubleshooting System Memory" |
The following DIMM has | establish a successful data link with | on page 102. |
been disabled by BIOS: | the memory controller. |
|
DIMM x |
|
|
|
|
|
PCIe Degraded Link Width | Faulty or improperly installed PCIe | Reseat the PCIe card in the specified |
Error: Embedded | card in the specified slot. | slot number. See |
Bus#nn/Dev#nn/Funcn |
| on page 81. If the problem persists, see |
Expected Link Width is n |
| "Getting Help" on page 125. |
|
| |
Actual Link Width is n |
|
|
|
|
|
PCIe Degraded Link Width | Faulty or improperly installed PCIe | Reseat the PCIe card in the specified |
Error: Slot n | card in the specified slot. | slot number. See |
Expected Link Width is n |
| on page 81. If the problem persists, see |
| "Getting Help" on page 125. | |
Actual Link Width is n |
| |
|
| |
|
|
|
PCIe Training Error: | Faulty or improperly installed PCIe | Reseat the PCIe card in the specified |
Embedded | card in the specified slot. | slot number. See |
Bus#nn/Dev#nn/Funcn |
| on page 81. If the problem persists, see |
PCIe Training Error: |
| "Getting Help" on page 125. |
|
| |
Slot n |
|
|
|
|
|
PCI BIOS failed to install | PCI device BIOS (Option ROM) | Reseat the expansion card(s). Ensure |
| checksum failure is detected during | that all appropriate cables are securely |
| shadowing. | connected to the expansion card(s). If |
| Loose cables to expansion card(s); | the problem persists, see |
| "Troubleshooting Expansion Cards" on | |
| faulty or improperly installed | |
| page 107. | |
| expansion card(s). | |
|
| |
|
|
|
Plug & Play Configuration | Error encountered in initializing PCI | Install the NVRAM_CLR jumper and |
Error | device; faulty system board. | reboot the system. See Figure |
|
| jumper location. If the problem persists, |
|
| see "Troubleshooting Expansion Cards" |
|
| on page 107. |
28