Dell MD3620I, MD3600I owner manual Type the New password, Password Guidelines

•Select the Setup tab, and then click Set a Storage Array Password.

•In the AMW, select the Logical tab, right-click and select Set

Password.

The Set Password dialog appears.

3If you are resetting the password, type the Current password.

NOTE: If you are setting the password for the first time, leave the Current password blank.

4Type the New password.

5Re-type the new password in Confirm new password.

NOTE: The password in Confirm new password and New password must be exactly the same.

6Click OK.

NOTE: You are not prompted for a password when you attempt to change the storage array configuration in the current management session.

Password Guidelines

Follow these guidelines when you create a password:

•Use secure passwords for your storage array. A password should be easy for you to remember but difficult for others to determine. Consider using numbers or special characters in the place of letters, such as a 1 in the place of the letter I, or the at sign (@) in the place of the letter a.

•For increased protection, use a long password with at least 15 alphanumeric characters. The maximum password length is 30 characters.

•Passwords are case sensitive.

NOTE: You can attempt to enter a password up to ten times before the storage array enters a lockout state. Before you can try to enter a password again, you must wait 10 minutes for the storage array to reset. To reset the password, press the password reset switch on your RAID controller module, see Figure 3-1.

72

Configuration: About Your Storage Array