Management: Installing Array Components 227
Control Panel

Removing the Control Panel

1
Turn off the array and host server.
2
Disconnect all the power cables connected to the array.
3
Remove the hard drives from:
– slots 0 to 2 in
PowerVault MD3600i
– slots 0 to 5 in
PowerVault MD3620i
See "Removing a Hard Drive" on page212.
NOTE: Mark each hard drive with it’s slot position as you remove it.
4
Slide the control panel out of the chassis after:
– Pushing the release tab toward the front of the array in
Power Vaul t
MD3600i
. See Figure16-13.
– Pulling the release pin toward the front of the array in
Power Vaul t
MD3620i
. See Figure16-14.
Figure 16-13. Removing and Installing the Control Panel—PowerVault MD3600i
1 control panel 2 release tab
21
book.book Page 227 Thursday, December 9, 2010 3:20 PM