Appendix 85
The
Boot Device Menu
appears, listing all available boot devices. Each device has a number
next to it.
3
At the bottom of the menu, enter the number of the device that is to be used for the current
boot only.
Changing Boot Sequence for Future Boots
1
Enter system setup (see page 82).
2
Use the arrow keys to highlight the
Boot Sequence
menu option and press <Enter> to access
the pop-up menu.
NOTE: Write down your current boot sequence in case you want to restore it.
3
Press the up- and down-arrow keys to move through the list of devices.
4
Press the spacebar to enable or disable a device (enabled devices have a checkmark).
5
Press plus (+) or minus (–) to move a selected device up or down the list.
Clearing Forgotten Passwords CAUTION: Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet
before opening the cover.
1
Shut down the computer through the
Start
menu (see page 18).
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it
from the network wall jack.
2
Turn off any attached devices and disconnect them from their electrical outlets.
3
Disconnect the computer power cable from the wall outlet, and then press the power button
to ground the system board.
4
Remove the computer cover (see page 55).
5
Locate the 3-pin password jumper (see page58) on the system board, and then attach the
jumper to both pins.
When you receive your computer, the jumper is attached to only one pin.
6
Replace the computer cover (see page78).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into
the computer.
7
Connect your computer and devices to electrical outlets, and then turn them on.
8
If you are prompted to press <F1> to continue, press <F1>.