Installing System Components 97
11
Replace the
cooling
shroud. See "Installing the Cooling Shroud" on
page 79.
12
Close the system. See "Closing the System" on page 63.
13
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
14
Press <F2> to enter the System Setup program, and check that the processor
information
matches the new system configuration. See "Entering the
System Setup Program" on page 38.
15
Run the system diagnostics to verify that the new processor
operates correctly.
See "Running the Embedded System Diagnostics" on page 126 for
information about running the diagnostics.
Power Supply
Your system supports a
250 W power supply
module.
Removing the Power Supply
1
Turn off the system and all attached peripherals.
2
Disconnect the power cable from the power source.
NOTE: You may have to unlatch and lift the optional cable management arm if
it interferes with power-supply removal. For information about the cable
management arm, see the system’s rack documentation.
3
Open the system. See "Opening the System" on page 62.
4
Disconnect all the power cables from the power supply to the system
board, hard drive(s), and optical drive. See Figure 3-17.
5
Remove the screw securing the power supply to the chassis and lift the
power supply to remove it from the chassis. See Figure 3-17.
book.book Page 97 Wednesday, August 12, 2009 4:51 PM