Message | Causes | Corrective Actions |
|
|
|
No boot sector on | Incorrect configuration | Check the |
hard drive. | settings in System Setup | configuration settings in the |
| program, or no operating | System Setup program. See |
| system on hard drive. | "Using the System Setup |
|
| Program and UEFI Boot |
|
| Manager" on page 37. If |
|
| necessary, install the |
|
| operating system on your |
|
| hard drive. See your |
|
| operating system |
|
| documentation. |
|
|
|
No timer tick | Faulty system board. | See "Getting Help" on |
interrupt. |
| page 133. |
|
|
|
PCI BIOS failed | PCIe device BIOS (Option | Reseat the expansion card. |
to install. | ROM) checksum failure | Ensure that all appropriate |
| detected during shadowing. | cables are securely connected |
| Cables to expansion card | to the expansion card. If the |
| problem persists, see | |
| loose; faulty or improperly | |
| "Troubleshooting an | |
| installed expansion card. | |
| Expansion Card" on | |
|
| |
|
| page 121. |
PCIe Training Error: Expected Link Width is x, Actual Link Width is y.
Faulty or improperly installed PCIe card in the specified slot.
Reseat the PCIe card in the specified slot number. See "Troubleshooting an Expansion Card" on
page 121. If the problem persists, see "Getting Help" on page 133.
Plug & | Play | Error encountered in |
Configuration | initializing PCIe device; | |
Error. |
| faulty system board. |
Install the NVRAM_CLR jumper in the clear position (pins 1 and 3) and reboot the system. See Figure
page 121.
About Your System
27
