Dell R210 owner manual PCI IRQ Assignments Screen, Serial Communication Screen

PCI IRQ Assignments Screen

Option	Description
<PCIe device>	Use the <+> and <-> keys to manually select an IRQ
	for a given device, or select Default to allow the BIOS to
	select an IRQ value at system startup.

Serial Communication Screen

Option	Description
Serial Communication	Selects whether the serial communication devices
(On without Console	(Serial Device 1 and Serial Device 2) are enabled in
Redirection default)	BIOS. BIOS console redirection can also be enabled and
	the port address used can be specified.
	Options are On without Console Redirection, On with
	Console Redirection via COM1, On with Console
	Redirection via COM2, and Off.
Serial Port Address	Sets the serial port addresses for the two serial devices.
(Serial Device 1=COM1,	NOTE: Only Serial Device 2 can be used for Serial Over
Serial Device2=COM2	LAN (SOL). To use console redirection by SOL, configure
default)
	the same port address for console redirection and the
	serial device.
External Serial	Specifies whether Serial Device 1, Serial Device 2, or
Connector	Remote Access Device has access to the external serial
(On without Console	connector.
Redirection default)	NOTE: Only Serial Device 2 can be used for Serial Over
	LAN (SOL). To use console redirection by SOL, configure
	the same port address for console redirection and the
	serial device.
Failsafe Baud Rate	Displays the failsafe baud rate used for console
(115200 default)	redirection. BIOS attempts to determine the baud rate
	automatically. This failsafe baud rate is used only if the
	attempt fails. This rate should not be adjusted.
Remote Terminal Type	Sets the remote console terminal type, either
(VT 100/VT220 default)	VT100/VT220 or ANSI.
Redirection After Boot	Enables or disables BIOS console redirection when the
(Enabled default)	operating system is loaded.

Using the System Setup Program and UEFI Boot Manager

45