Steps
1.Using a #1 Phillips screwdriver, loosen the captive screws that secure the network daughter card to the system board.
2.Hold the network daughter card by the edges on either side of the touch point and lift the card to remove it from the connector on the system board.
3.Slide the network daughter card away from the back of the system until the Ethernet connectors are clear of the slot in the back panel.
4.Lift the network daughter card out of the chassis.
Figure 42. Removing and installing the Network Daughter Card (NDC)
1. | captive screw socket (2) | 2. connector on the system board | |
3. | captive screw (2) | 4. | touch point (2) |
5. | network daughter card | 6. | back panel slot for Ethernet connectors |
Next steps
1.Replace the network daughter card. See Installing the network daughter card.
2.Follow the procedure listed in After working inside your system.
Related videos
96
