Digi W manual Configuring Inbound PPP Connections Example

set user name=name ipaddr=ip-address

where

•name is the user’s name

•ip-addressis one of the following: (a) A standard IP address in dotted decimal format. (b) 0.0.0.0, which means the remote user will supply the IP address (c) ippool, which means that the user will be assigned an IP address from an IP address pool. See the set ippool command in the Digi One/PortServer TS Command Reference.

Example: set user name=pppin ipaddr=ippool

6.If you used the IP address pool option in the previous step, specify the following subnetwork mask using the following command: (a mask of 255.255.255.255 is required)

set user ipmask=255.255.255.255

7.To configure an IP address for the local end of the PPP connection, enter the following command:

set user name=name localipaddr=ip-address

where name is the user’s name and ip-addressis the IP address to assign to the local end of the PPP connection. This address must be unique. That is, no other user can be assigned this address and it cannot be the IP address for the Ethernet interface.

Example: set user name=pppin localipadr=199.1.1.2

Configuring Inbound PPP Connections: Example

This example shows a very simple PPP inbound configuration. Here are some points on this configuration:

•The port is set up for inbound connections (dev=min).

•RTS and CTS are used for flow control.

•The baud rate has been set to 115000 bps.

•The user has been configured to use an IP address pool

set ports range=3 device=min

set flow range=3 ixon=off ixoff=off rts=on cts=on set line range=3 baud=115000

set user name=pppin protocol=ppp netservice=on defaultaccess=netservice

set user name=pppin ipaddr=ippool

set user name=pppin localipadr=199.1.1.2

Configuring Outbound PPP Connections: Command Line

This section describes how to configure outbound PPP connections. Use it to configure outbound only connections or to configure the outbound portion of bidirectional connections.

Note: CHAP authentication works between two Digi devices. CHAP will be negotiated to PAP for all other connections

28 Chapter 8 Configuring PPP