Easy wireless setting
Easy wireless setting
With this setting, you do not need any complicated LAN setting procedures.
The network type will be AdHoc mode.
CAUTION: This function can be used only when logged in by Administrative right with Windows XP and Windows Vista, and cannot be used with Windows 2000. Windows XP should be Service Pack 1 or later version.
Setting Procedures
1.Turn on the projector and select “Wireless” from the input menu of the projector.
2.Select “Wireless Setting” from the projector menu and press SELECT button.
3.Select “SIMPLE” with the Point 7 8 buttons. Press the Point button then the “Please wait...” message will appear and switching operation will start. Switching will take a while and after completing the operation the message “Ready for use” will appear. During the switching period, the projector cannot be operated. (“SIMPLE” LAN settings will be shown by pressing SELECT button. The settings cannot be changed.)
4.Activate “Network Capture 4” which is installed in the computer.
5.Click Wireless Easy setting button on the operation screen. The Wireless LAN setting screen will appear and the computer will start to set up the Wireless LAN setting. (Adjust the computer’s Wireless LAN environment to the “SIMPLE” setting LAN environment.)
After completing the settings, the computer will start searching the projector which was set as “SIMPLE” and will display the name of the projector or the IP address on the projector list.
Confirm whether the LAN has been set correctly and works properly. Refer to “4. Wired LAN configurations” ➔ “Confirming the operation” (p.28) for the confirmation procedures.
If the network setup is not succeeded, the error screen will appear.
Setting screen
Error Screen
Wireless easy setting button
39
