Power control and status check

About projector condition

Status

Description

Normal

Projector is operating normally.

Power management in operation

Power management is operating

Lamp failure

Lamp failure is occurring

Abnormal Temperature

The temperature of the projector became too high

Cooling down after abnormal Temp.

Projector detects abnormal temp. and is cooling down itself.

Standby after Abnormal Temp

Projector detects abnormal temp. and is set into standby mode.

Power failure

Power failure has occurred inside the projector. Projector is turned off.

 

Unplug the AC cord and contact a qualified service personnel for service.

 

If the power failure occurs on the projector, "Power failure" is indicated on

 

the status column and the information icon appears on the power column

 

as shown below. Click this icon to display further information of the power

 

failure.

Click this icon to display further information of the power failure.

When a security (PIN code lock) has been set on the projector, you also cannot control it through the network. To control the projector through the network, unlock the security on the projector using with the projector's menu control.

Caution about turning on/off the projector via the networks

When turning on/off the projector via the networks, preset the projector as follows:

1.Select “Setting” from the Projector menu.

2.Select “Standby mode” from the Setting menu and set it as “Normal”.

If you set this function as Normal, the network part of the projector is constantly provided with power even if the projector is turned off. If you set this as Eco, then the network part will be turned off when you turn off the projector. Consequently, you cannot turn on/off the projector via the networks.

65

Page 65
Image 65
Eiki QXXAVC922---P owner manual About projector condition, Status Description