Eiki QXXAVC922---P Change the mode of the registered projector, Status, Controlling the projector

Chapter 7 Controlling the projector

Change the mode of the registered projector

To change the mode of the registered projector, select a mode with the pull-down menu button under the IP address of the target projector and then click Set button.

Mode	Operation
Control	Controlling the projector
Both control	Controlling and displaying images
Visual control	Displaying the images
OFF	Excluding from the multi-control
Delete	Deleting from the multi-control

*The multi control item is not changed during using the network viewer function. It is not available with the light mode.

Status

If some of the registered projectors are disabled by some reasons (such as disconnecting the power source, disconnecting the LAN cable, disconnecting from the network), control changes will continue to be effective for the projectors that are still active. At the same time, the deactivated projectors are excluded from the multi-control. The status of the registered projectors are in- dicated under the projector name. See the table below for status indications.

	Status
Status	Description
(blank)	The projector is connected to the network correctly
No connect	The projector may not be connected to the network. Please check the connection and network
	configuration of this projector.
PIN code error	The PIN code is incorrect. The PIN code for the multi-controlled projectors must be the same.
	Change the PIN code of this projector to the common PIN code. (p.30, p.40)
File Error	Not displaying the images. Check if this projector is using the Network Capture function or
	Network Viewer function individually, or in the standby mode.

* The projector updates the status at the time when the multi-control function is executed.

✐If the multi-controlled projector is in the standby mode, items of "PC adj.", "Control" and "Setting" cannot be operated.

✐Cannot register, delete or change the multi-control setting during using the network viewer function.

✐It is recommended that a specified projector should be chosen for setting as a master when you use this multi-control function. The control for the multi-controlled projectors will become too complicated operation if this function is used for each projector.

✐If the registered projector is not connected to the network, it will take a while to complete the multi-control operation because of waiting for the response from each registered projector.

82 ✐ There are some disabled items in the multi-control function for the light mode.