Removing the Rear Case
Disassembly usually starts with removal of the back case. For assistance with disassembly, consult your manufacturer's service manual.
To remove the rear case:
•Carefully lay the display on its face on the padded work surface and remove the screws that attach the rear case to the bezel or frame.
•Slowly pull the rear case upward.
•Disconnect any cabling that may be attached to the rear case
•While removing the rear case, note the clearance between the inside rear surface of the case and any of the monitor’s circuitry. If there is not enough clearance to move this circuitry about.25 inch (6 mm) toward the rear of the case, you may be unable to successfully install a touchscreen on the display and completely reinstall the back case. Contact Elo Applications Engineering
Removing the LCD
1Continue disassembling the display until the face of the LCD is completely exposed. The degree of disassembly required will vary from display to display.
2The next step will be to remove the LCD from the display’s housing. Several cables may have to be unplugged from the LCD before it can be removed. Typically these cables are:
•The input video connector. A
•The
•Various cables connected to the power switch, pilot light, front panel controls, etc. Other cables may have to be unplugged from the electronics chassis. The need for this may not be apparent until the chassis is removed, as instructed below. As you pull the LCD out of the frame, make sure to watch for other cables that need to be disconnected. After removal, set the LCD face up on a padded, static free work surface.
