Elo TouchSystems IntelliTouch SecureTouch IntelliTouch 2500S Serial Controller, Environments

IntelliTouch 2500S Serial Controller

Electrical

Supply Voltage and Current

Interface

Baud Rate

Operating Modes

Touch Resolution

Conversion Time

Reliability

+5 Vdc, nominal (+4.75 to +5.25 Vdc).

60 mA, typical at +5 Vdc. Average power dissipation is 0.3 W, typical.

Supply must be capable of sourcing 100 mA, minimum.

Total noise and ripple requirement must be less than 100 mV (p-p) for frequencies below 1 MHz, and less than 50 mV (p-p) for frequencies above 1 MHz.

EIA 232E (Serial RS-232), DCE configuration. 8 Data Bits, 1 Stop Bit, No Parity, Full Duplex.

Hardware handshaking: RTS/CTS

DSR is pulled HIGH (>+3V) by the 2500S when connected and powered. DTR is ignored

9600 (default) and 19200

Full IntelliTouch SmartSet or E281A-4002 protocols, jumper selectable.

Initial/ Stream/ Untouch/ Z-axis Enable Modes.

4096x4096, size independent, 255 levels of Z (pressure).

Approximately 10.4 ms per coordinate report.

MTBF greater than 300,000 hours per MIL-HDBK-217-F2 (using the parts stress calculation method for ground benign environment with an ambient temperature of 25° C).

Environments

Temperature	Operating:0°C to 65°C.
	Storage:-25°C to 85°C.
Humidity	Operating:10% to 90% RH, non-condensing.
	Storage:10% to 90% RH, non-condensing.
Operating Altitude	10,000 feet.
Shock and Vibration	Three axis since wave, 50 Hz to 2kHz, 1 G, 2 minutes/Octave with dwell on
	resonances.
ESD	Per EN 6100-4-2 1995: Level 4. Contact discharge 8kV, air discharge 15kV.
Flammability	The printed circuit board substrate is rated 94V0. All plastic components, such a
	headers and connectors, are also rated 94V0.
Physical Characteristics
Construction	Four-layer surface-mount design with internal ground plane for EMI
	suppression.
Dimensions	Total Width: 2.36 inches (59.94 mm), including connectors
	Total Length: 3.30 inches (83.82 mm)
	Total height: 0.40 inches (10.16 mm)
	All mounting holes are plated through for chassis ground connection. Refer to
	the drawings at the end of this document.

B-71