Elo TouchSystems IntelliTouch SecureTouch Re-assembling the Display, Horizontal escutcheon plate

2Mount the USB bulkhead connector using one of the above techniques.

Note: If mounting to a non-grounded location, attach a grounding cable to one of the jackscrews and terminate to ground).

3Connect one end of the 18" USB cable to the USB connector of the IntelliTouch serial controller, and connect the other end to the receiving connector of the bulkhead.

4Take up the excess cable with zip ties and secure.

5Label the monitor to indicate that an IntelliTouch 2500U controller has been installed inside the display.

Brush Direction

Figure 2.13 Horizontal escutcheon plate

Re-assembling the Display

Re-assemble the display by completing the disassembly steps in reverse order. Take care to connect everything correctly and completely.

•Various methods can be used to obtain power for the internal RS-232 controller and USB controller. Refer to the Power section of this document, page 44, to determine the method which is best for your particular situation.

2-47