Installation

Encoder Feedback Cables

The encoder must be connected to the motor so a clockwise rotation of the motor shaft, as viewed from the shaft end of the motor, will cause a count up condition. The cable drawings below (for the two types of encoders EMC supplies) assume that CW motor rotation will cause CW encoder shaft rotation. This is the case if the encoder is mounted on the rear of the motor.

Figure 10 Model SDC-15-1 Encoder Connections

Figure 11 Model SDC-25-1 Encoder Connections

9

Page 17
Image 17
Emerson 400276-01 operation manual Encoder Feedback Cables, Model SDC-15-1 Encoder Connections