Adjusting the Image Shape

In most cases, you can maintain a square or rectangular image by placing the projector directly in front of the center of the screen with the base of the lens level with the bottom of the screen.

If the projector is slightly tilted (within a range of 30° up or down), you can use the Keystone keys on the projector’s control panel or the projector’s Keystone menu (see “Using Keystone Correction” on page 37) to correct vertical keystone distortion.

Projector tilted up

Corrected image

Projector tilted down

If your image is shaped like or , you’ve placed the projector off to one side of the screen at an angle. Place it directly in front of the center of the screen, facing the screen squarely.

Using Keystone Correction

To adjust your image when it is wider on the top or bottom, do the following:

■Press the or buttons on the projector until you are satisfied with the shape of the image.

Keystone buttons

note

The image will be slightly shorter after adjusting.

Projecting 37