Light | Status | Description |
|
|
|
| Green | It’s time to replace the lamp. See page 89 for instructions. If you continue |
|
| to use the lamp after the replacement warning, there is an increased |
| Flashing orange | possibility that the lamp may break. |
|
|
|
| Green | No air filter. Make sure that the air filter is securely installed; see page 87. |
|
| If the error continues when the air filter is installed, there is a problem |
| Orange | with the air filter sensor. Stop using the projector, disconnect the power |
|
| cord, and contact Epson as described on page 106. |
|
|
|
| Green | Low air flow. If you see a message saying that the air filter is clogged, |
|
| make sure that the air filter is clean. If it is clogged, clean it or replace it |
| Flashing orange | with a new filter; see page 87. |
|
|
|
| Red | There is a problem with the fan or temperature sensor. Stop using the |
|
| projector, disconnect the power cable, and contact Epson as described |
| Flashing red | on page 106. |
|
|
|
| Red | The projector is overheating, which turns the lamp off automatically. Wait |
|
| until the cooling fan stops, about five minutes, then unplug the power |
| Red | cord. Plug the power cord back in and press the P Power button. Make |
|
| sure the room temperature is not above 95 °F (35 °C) and there is plenty |
|
| of space around and under the projector for ventilation. |
|
| The air filter may be clogged. Clean or replace it as described on page 87. |
|
| If the projector continues to overheat after you clean the air filter, the |
|
| problem may be caused by damage to the cooling fan or temperature |
|
| sensor. Contact Epson for help. |
|
| Warning: Except as specifically explained in this User’s Guide, do not |
|
| attempt to service this product yourself. |
|
| If you installed the optional Epson smoke filter in the projector, try the |
|
| following: |
|
| ■ If you are using the projector at a high altitude (4,900 feet [1500 |
|
| meters] or higher), set High Altitude Mode to On (see page 61). |
|
| ■ You may need to set the Brightness Control to Low (see page 59). |
|
| ■ Replace the smoke filter (see page 87). |
|
| If the error continues, stop using the projector, disconnect the power |
|
| cable from the electrical outlet, and contact Epson as described on |
|
| |
|
|
|
96Solving Problems