note

You must be projecting an image for this button to have any effect. The Auto button works only with computer images.

Make sure Auto Setup is turned on to adjust the source automatically; see page 57.

■Or press the Menu button on the remote control, select the Settings menu, and press Enter. From the Settings menu, select Keystone and press Enter. Use the pointer button on the remote control to adjust the keystone setting as needed.

Correcting Computer Images

If you’re connected to a computer and the image doesn’t look right, press the Auto button on the remote control (or the Enter button on the projector’s control panel). This automatically resets the projector’s tracking, sync, resolution, and position settings.

If vertical stripes appear in the projected image and the Auto button doesn’t correct the problem, adjust the projector’s Tracking setting. See page 102 for instructions.

If the image appears fuzzy or flickers and the Auto button doesn’t correct the problem, adjust the projector’s Sync setting. See page 102 for instructions.

note

You can also adjust the volume using the projector’s menu system. See page 59.

Adjusting the Volume

You can use the buttons on the remote control or projector to increase or decrease the volume for the projector’s built-in speaker or an external speaker system connected to the projector. Press the button to increase the volume, or the button to decrease it.

38Projecting