Turning On Password Protection
If you enable the Power On Protect setting, a screen appears requesting the password whenever the projector is turned on.
Make sure that you’ve set a password for the projector as described on page 69. Then follow the steps below:
1.Press and hold down the Freeze button until you see the Password Protect menu:
2.Select Power On Protect and press Enter. Then select On and press Enter.
3.Press Menu to exit the Password Protect menu.
If you lose the remote control, you will not be able to enter the password, so keep the remote control in a safe place at all times.
note
If you are prompted for a password, press and hold down the Num key on the remote control while you use the numeric keypad to enter the password.
If you enter the password incorrectly three times in succession, the projector’s operation is locked and you’ll need to turn it off and disconnect the power cord, then reconnect it. If an incorrect password is entered 30 times in succession, the projector is locked and you’ll need to contact Epson to unlock it. See “Where To Get Help” on page 106.
Configuring the Projector 71