Replacing the Lamp
The projection lamp typically lasts about 4000 hours. It is time to replace the lamp when:
■The projected image gets darker or starts to deteriorate.
■The message Replace the Lamp appears on the screen and when the lamp comes on and the lamp warning light 
flashes orange. To maintain projector brightness and image quality, replace the
lamp as soon as possible.
■The lamp warning light 
flashes red (the lamp is burnt out).
Contact your dealer or contact an Epson authorized reseller for a replacement lamp. Request part number V13H010L45. To find the nearest reseller, call
Follow these steps to replace the lamp:
1.Turn off the projector.
2.When the P Power light stops flashing, unplug the power cord.
3.Let the projector cool for at least an hour (if it has been on). The lamp is extremely hot immediately after use.
4.To release the lamp cover, insert the screwdriver included with the new lamp as shown, then remove the cover.
note
Turn off the projector when not in use to prolong the life of the projector lamp.
You can check how long the lamp has been in use (see page 91).
Lamp life results will vary depending upon mode selected, environmental conditions and usage.
warning
Let the lamp cool fully before replacing it.
In the unlikely event that the lamp has broken, small glass fragments may be present and should be removed carefully to avoid injury.
Maintaining the Projector 89