note
To monitor a projector when it’s in standby mode (plugged in but not turned on), you must select Network On as the Standby Mode setting in the projector’s menu system (see page 61).
For detailed status information,
note
To create projector groups in EMP Monitor, refer to the
Monitoring Your Projectors
The EMP Monitor screen lets you monitor your projector(s) status and check if a problem has occurred.
For the most current status, click the Refresh button.
The following table describes the EMP Monitor status icons:
Group status icons
No warnings or problems. All projectors in the group are operating normally.
Warning or problem. A projector in the group has a warning or problem.
Notification. A projector in the group requires immediate attention.
Monitoring disabled. Right click the icon and select
Monitoring Enabled to begin monitoring the group.
Data is currently being updated.
Type status icons
No warnings or problems.
Warning or problem.
Notification.
Monitor Password error. No monitor password was entered when the projector was registered, or an incorrect password was entered.
Monitoring disabled.
Data is currently being updated.
Network error (for example, the projector is not connected to the network, or power cable is disconnected).
You may also see this error if Network Off is selected in Standby Mode (see page 61).
Network error (Esc/VP.net communication error).
80Monitoring the Projector Over a Network