Epson 6110i Setting the Projector ID, Setting the Remote Control ID

note

If you’re using a remote control ID other than the default ID of zero, you have to set the ID each time you turn on the projector.

Setting the Projector ID

The projector’s default ID is set to Off. This lets it respond to commands from any remote control. To change the ID, follow these steps:

1.Press the Menu button on the remote control. You see the projector’s menu screen.

2.Select Extended > Projector ID.

3.Use the pointer button to highlight the new ID, and press Enter to select it.

4.When done, press Menu to exit the menu system.

Setting the Remote Control ID

The remote control’s default ID is zero. This lets you operate any projector. To set it to operate a specific projector, follow these steps:

1.Point the remote control at the projector you want to be able to operate.

2.Press and hold the ID button on the remote control.

48Using the Remote Control