7.4Adjusting the Volume of Water Used in the Water Saver Option (GW only) – Phase 3 to 5
You can increase or decrease the volume of water added during the shower rinse on the Water Saver option. Enter the Option Adjustment Mode. Use the WATER LEVEL buttons to select the volume of water you wish to be used in the shower rinse
HIGH WATER LED ON | more water |
MED WATER LED ON | Default set water volume |
LOW WATER LED ON | less water |
Press POWER to return to normal mode.
7.5Auto Water Fill Level Adjustment (GW only) Phase 3-5
If the user is not satisfied with the level that Smartdrive fills to on auto water level, they can increase or decrease the fill level that auto will select.
NB. If there is not enough water for the load, we recommend you check by pausing Smartdrive and pushing the clothes down to see how much spare water is at the bottom of the bowl. Clothes often float and Smartdrive can sense the water under the clothes.
Enter the Option Adjustment Mode. Use the cycle buttons to increase or decrease the amount of water selected.
FAVOURITE LED on | less water |
PERM. PRESS LED on | default set level |
WOOL LED on | more water + |
DELICATE LED on | more water ++ |
REGULAR LED on | more water +++ |
7.6Out Of Balance Recovery Adjustment (GW and MW only) Phase 3-5
When Smartdrive is spinning it senses if the wash load is out of balance. It stops and retries to spin. If Smartdrive still senses an unbalanced load it will stop, give a short burst of beeps every five seconds and the RINSE or SPIN light will flash. The load must be redistributed more evenly. However, GW and MW models have an option where Smartdrive will try to automatically correct the out of balance load. If it detects an unbalanced load, it will fill with water and agitate to redistribute the load before trying to spin up again.
Smartdrive has this option turned off to conserve water. To programme Smartdrive to automatically try and correct out of balance loads follow the instructions below.
1.Enter the Option Adjustment Mode as explained in section 7.0.
2.Use the HEAVY DUTY button to select the Out of Balance recovery option you prefer. HEAVY DUTY light on = automatic
HEAVY DUTY light off = stops
3.Press POWER to return to normal mode.
- 30 -
