Fisher & Paykel 517735 Installation, Removing Transit Restraint, Inlet Hoses, Drain Hose

3.0 INSTALLATION

REMOVING BOWL PACKER AND ACCESSORIES

Remove the outer packaging. Leave Smartdrive standing upright.

Lift the lid and remove the bowl packer. Remove hoses and accessories.

REMOVING TRANSIT RESTRAINT

Rotate the agitator anti-clockwise for 3 revolutions. (This unscrews the transit restraint from the base of Smartdrive.) The wash bowl will then be free to move from side to side.

Remove the bottom cardboard packer. Tilt Smartdrive and check that the red transit restraint has come away with the packer.

Keep the transit restraint and packers for future use.

Please make sure the transit reestraint has ben removed before operating Smartdrive

INSTALLATION

In Smartdrive there is a bag with:-

•4 rubber inserts for the levelling feet

•4 sealing washers (2 with filters)

•1 hose guide

INLET HOSES

Place filtered sealing washers into the straight ends of the white inlet hoses and connect to taps. (Dome end of washer towards tap.)

Place sealing washers into elbow ends of the white inlet hoses and connect to inlet valves. Inlet valves are marked on the back of Smartdrive.

H = Hot C = Cold.

NB. The new inlet hoses have the filters and washers fitted.

Cold Supply Only

If you only have a cold water supply, an inlet valve cap (blanking cap) MUST be connected to the hot inlet valve. The cap prevents water leaking out the hot valve. The cap is Part No. 388491.

DRAIN HOSE

Pull the black drain hose out from the back of Smartdrive by pulling the exposed part of the hose downwards and outwards. The hose guide guides the drain hose over the tub or standpipe. It MUST be fitted to the drain hose.

To prevent siphoning:

The drain hose should not extend more than 20 mm from the end of the guide.

The height of the standpipe or tub should be between 850-1200mm. The drain hose can be trimmed to length.

Place the drain hose in the tub or standpipe.

- 4 -