8.0 DIAGNOSTIC MODE
Allows the following status information to be | Allows control of the following:- |
determined: - | Pump |
Last Fault. | Hot Water Valve |
Lid switch status. | Cold Water Valve |
Out of Balance switch status. | Restart |
Size. | Recycle |
Additional information | Hot Bowl Flag |
|
|
For IW information see Appendix E.
8.1WHAT WAS THE LAST FAULT?
To enter Diagnostic Mode turn the power on at the power point and off at the console. Press and hold the WASH TEMPERATURE DOWN then press the POWER button. Smartdrive will give 2 short beeps. Phase 1 & 2 Only press ADVANCE button once.
From Diagnostic mode press the SPIN buttons until the HOLD and SLOW SPIN LEDs are on, (Diagnostic mode level 3). The WASH PROGRESS LEDs will now display the fault code.
Note
This window for the LED is not there on some LW & AW models. The LED will still be visible under the panel for diagnostic purposes.
128 | 64 | 32 | 16 | 8 | 4 | 2 |
short rinse wash
Wash progress LED's Binary Code
Fault Code: 32+16+1 = 49
1
Advance
spin
Note
The spin LED is used for optical download. When downloading it may be flickering. It will not necessarily be part of the fault code.
short | rinse |
| Advance |
| spin | ||
wash |
|
|
|
Spin LED's Showing |
| 8 | fast |
| 4 | med Power | |
Diagnostic Mode level | 2 | slow | |
3.
1 
hold
(Last Fault code) | start |
| pause |
| delay |
LED on | start |
LED off | spin |
speed |
Note: The fault code will only be displayed for 8 cycles after the fault has been rectified. If there has been no fault within the last 8 cycles all the wash progress LEDs will be off. In this case it is most unlikely that the Motor Controller will be faulty.
- 31 -
