8.4RESTART
If a problem occurs in Smartdrive, it will try to correct the problem and retry. Smartdrive will rectify any problems of a temporary nature. If there is a continuous problem Smartdrive will retry several times. This process may take up to 10 minutes depending on the type of problem. If Smartdrive still cannot resolve the problem, the fault code is displayed and Smartdrive will beep continuously. RESTART ON is the default state. This forces Smartdrive to retry when a problem occurs. While servicing Smartdrive turn
RESTART OFF. This will allow any fault in the system to show up immediately.
To enter Diagnostic Mode turn the power on at the power point and off at the console. Press and hold the WASH TEMPERATURE DOWN button then press the POWER button. Smartdrive will give 2 short beeps. Phase 3 Only press ADVANCE button once. From Diagnostic mode use the WATER LEVEL DOWN button to turn the RESTART on or off.
LOW WATER LEVEL LED OFF = RESTART OFF.
LOW WATER LEVEL LED ON = RESTART ON. (Default)
RESTART status can be easily identified when Smartdrive is first turned on -
•If none of the 5 leftmost green wash progress LEDs are on, the RESTART is on.
•If the 5 leftmost green wash progress LEDs are flashing, the RESTART is off.
NB. RESTART is a service aid only and should be left ON in the customer’s home. To return to normal operation, and to reset the RESTART feature to the default setting, power off Smartdrive.
8.5RECYCLE
After servicing, Smartdrive may require an extended test where Smartdrive can be left to complete a number of wash cycles. By turning on RECYCLE Smartdrive will continuously repeat the selected wash cycle until RECYCLE is turned off.
Enter Diagnostic mode as described above (RESTART). Use the WATER LEVEL UP button to turn RECYCLE on or off.
MEDIUM WATER LEVEL LED ON = RE-CYCLE ON.
MEDIUM WATER LEVEL LED OFF = RE-CYCLE OFF. (Default setting).
RECYCLE status can be easily identified when Smartdrive is first turned on: -
•If the 3 rightmost rinse and spin progress LEDs are on, recycle is off.
•If the 3 rightmost rinse and spin LED’s flash, recycle is on.
NB. Recycle is designed as a service aid only and should be OFF in the customer’s home. To return to normal operation, and to return recycle to the default setting, power off Smartdrive.
- 33 -
