Fluke 2620A, 2625A user manual Operating the Instrument from the Front Panel, Channel Configuration

Operating the Instrument from the Front Panel

3

Channel Configuration

Table 3-3. Resistance

ChannelG

FunctionG

Range

TerminalsG

PRESS

F

E

(NoteG1)

E

E

THESE

BUTTONS:

D

D

D

D

TO

0

OFF

Auto

2T

(Completes

SELECT

1

V DC

300.00 Ω

4T

Selection

FROM

.

V AC

3.0000 kΩ

and returns

THESE

.

Ω

30.000 kΩ

to Inactive

CHOICES:

Hz

300.00 kΩ

Mode)

20

°C or °F

3.0000 MΩ

10.000 MΩ

Note 1. Determine the highest resistance value anticipated for this channel. Then select a range large

enough to accommodate this value. If the highest resistance cannot be anticipated, select “Auto”.

Note 2. "4T" allowed on channels 1 through 10 only. For each 4T channel, an additional channel (10

channels higher) is reserved to provide the third and fourth terminals. Channels 11 through 20 are

available for this purpose. Any channel so reserved cannot be used for other definitions.

Table 3-4. Frequency

ChannelG

FunctionG

Range

PRESS

F

E

(Note)G

E

THESE

BUTTONS:

D

D

D

TO

0

OFF

Auto

(Completes

SELECT

V DC

900.00 Hz

Selection

FROM

1

V AC

9.0000 kHz

and returns

THESE

.

Ω

90.000 kHz

to Inactive

CHOICES:

.

Hz

900.00 kHz

Mode)

20

°C or °F

1.0000 MHz

Note: Determine the highest frequency anticipated for this channel. Then select a range large enough to accommodate this value. If the highest frequency cannot be anticipated, select "Auto". "Auto" does not cause any delays for frequency measurements.

3-7