Fujitsu 2.1 , , ,

Chapter 9 Messages

9.3 Detailed Error Codes

ETERNUS VSS Hardware Provider 2.1 User’s Guide

126

invalid OLU. Check the device that is the copy source or the device

partition information of the copy destination, and retry the

function. If this error still occurs, collect material for

troubleshooting, and then contact your Fujitsu system

engineer (SE).(*1)

invalid BoxID. Check the connection conditions between cabinets, and retry.

If this error occurs again, then contact your Fujitsu customer

engineer (CE).

invalid Role. Check the connection conditions between cabinets, and retry.

If this error occurs again, then contact your Fujitsu customer

engineer (CE).

setup is inadequate Take one of the following actions:

•Checking/Setting the license of the Advanced Copy option

•Checking/Setting device resources such as "Unset table

size", "Lack of table size", and "Unset REC buffer size".

communication interrupted. Check the connection state between the cabinets, and retry

processing. If the error occurs again, contact a Fujitsu

systems engineer (CE).

the session mode was not changed. Check the connection status between cabinets and then retry.

If this error occurs again, call your Fujitsu customer or

systems engineer (CE or SE).

the session mode crosses. Check the connection status between cabinets and then retry.

If this error occurs again, call your Fujitsu customer or

systems engineer (CE or SE).

the operation of SnapOPC was failed. Take one of the following actions:

•Check the partition information for the copy destination

disk, and then rerun the command.

•Check the status of SnapOPC session, and then try again.

•SnapOPC is not supported by this device. Try again using

SnapOPC+.

If this error occurs again, call your Fujitsu customer or

systems engineer (CE or SE).

the operation of REC buffer was failed. Check the settings status of the REC transfer buffer and then

rerun the command. If this error occurs again, call your Fujitsu

customer or systems engineer (CE or SE).

the operation of concurrent suspend was

failed.

Check the status of all sessions, and then rerun the

command. If this error reoccurs, call your Fujitsu customer or

systems engineer (CE or SE).

invalid Snap Data volume. Take one of the following actions:

•When a copy type is SnapOPC/SnapOPC+, check that

the copy destination is the Snap Data Volume.

•When a copy type is SnapOPC/SnapOPC+, check that

the copy source is not the Snap Data Volume.

•When a copy type is a type other than SnapOPC/

SnapOPC+, check that the copy destination and source

are not the Snap Data Volume.

•For Snap Data Volume initialization, check that the Snap

Data Volume is specified.

If this error occurs again, call your Fujitsu customer or

systems engineer (CE or SE).

Detailed error code Action