Fujitsu RX600 Switching the server on and off, Switching the server off, Other On/Off options

Switching the server on and off Starting up and operation

Switching the server off

The power-on indicator lights up green (item 6 in figure 13 on page 55).

ÊShut down the operating system properly.

The server is switched off automatically and goes into standby mode. The power-on indicator lights up orange.

IIf the operating system does not switch the server off automatically, press the On/Off button for at least four seconds and/or send a corresponding control signal.

Other On/Off options

Besides the On/Off button, the server can be switched ON and OFF in the following ways:

–Specified switch-on time/switch-off time

The server is switched ON or OFF at a time specified in the ServerView program

–Ring Indicator

The server is switched on by an internal or external modem.

–Wake On LAN (WOL)

The server is switched on by a command via the LAN (Magic Packet).

–After power failure

The server automatically reboots following a power failure (depending of the settings in the BIOS).

–Power button override

The server can be switched off immediately by pressing and holding the On/Off button (approx. 4-5 sec.).

VCAUTION!

There is a risk that data may be lost.

–IPMI

The server is switched on from an IPMI console (via the COM1 serial interface or the RJ45 LAN interface).

68 Operating manual RX600 S4