Antenna radiator
Guide pin (XN20AF, XN24AF only)
Waveguide
Radiator bracket
| Hex bolt (M8X40), 8 pcs. |
| (XN20AF, XN24AF only) |
| Hex bolt (M8X35), 8 pcs. |
| Flat washer |
| Spring washer |
(XN12AF only) |
Figure 1-3 Fastening the radiator to the radiator bracket
Fastening the antenna unit to the mounting platform
The antenna unit may be assembled before hoisting it to the mounting platform. However, do not hoist the antenna unit by the radiator. Always hoist the unit by its housing. When using a crane or hoist, hoist the unit by the hoist rings which should be fastened to the bolt fixing covers of the antenna housing.
CAUTION
DO NOT hoist the antenna unit by the radiator; lift it by the hoist rings. (Be sure to remove rings after hoisting the antenna unit.)
Hoist | NO! |
ring |
|
1.Construct a suitable mounting platform referring to the outline drawing at the back of the manual.
2.Drill four mounting holes of 15 mm diameter and one cable entry hole of about 50 mm diameter in the mounting platform.
3.Lay the rubber mat (supplied) on the mounting platform.
