Furuno FR-2125V installation manual Setting catch to hole in stay

b)While pushing the stopper, set the catch on the display unit in the hole at the front edge of the stay.

Stopper

Catch

Stay

Figure 1-9 Setting catch to hole in stay

c) Release hand from stopper.

Release stopper; fix stay.

Figure 1-10 Stay fixed

6.Fasten the display unit to the mounting location at front fixing holes (2 points) with M10 bolts, nuts and flat washers, using the pipe box spanner (supplied).

You cannot fasten the display unit at the rear fixing holes while the monitor is raised.

7.Retract the stay and lower the monitor. Pull the monitor toward you by the handle at the front of the display unit until you hear a click.

8.The rear left fixing hole is hidden under the PTU board cover. Remove the cover as follows:

(1)Unfasten three M4X8 screws to remove the lead-in cover (V) which hides the PTU section. Slide the cover to remove it.

REAR SIDE

Pan-head Screw

M4X8, 4 pcs.

Lead-in Cover (V)

Figure 1-11 How to remove the lead-in cover

1-7