ADJUSTABLE FEATURES
SX TRANSISTOR CONTROLS | Page 55 |
Section 6. SX FAMILY GE HANDSET INSTRUCTIONS
Section 6.1 General Features
The GE Handset is a
START-UP DISPLAY SEQUENCE
Key Switch On
Verify Each LED Segment
8 8 8 8
Note: The Handset is the same for all GE controls, however, the cable will change between some control types.
Section 6.2 Purpose / Setup Functions
The purpose of the Handset is to allow authorized personnel to perform the following functions of the SX family of Controls:
• | Monitor existing system fault codes |
• | Monitor intermittent random fault codes |
• | Monitor battery state of charge on systems with BDI |
• | Monitor hourmeter reading |
If Maintenance Code
Is Active
Display Code
For Four Seconds and
Activate Speed Limit
(if selected)
If Maintenance Code
Is Not Active
• Monitor or adjust the following control functions: | |
♦ | Creep speed |
♦ | Armature Controlled Acceleration and 1A Time |
♦ | Regenerative Braking Current Limit and Disable |
♦ | Armature and Field Current Limit |
♦ | Plugging Distance (Current) |
♦ | Pedal Position Plug Range or Disable |
♦ | 1A Drop Out Current or Disable |
♦ | Speed Limit Points |
♦ | Truck Management Fault Speed Limit |
♦ | Internal Resistance Compensation for Battery |
♦ | State of Charge Indication |
Battery Voltage ( 36/48 volts is auto ranging ) | |
♦ | Selection of Card Operation Type. |
Warning: Before connecting or disconnecting the Handset tool, turn off the key switch, unplug the battery and jack up the drive wheels of the vehicle.
At the transistor control traction card, unplug the "Y plug" if the dash display is in use, and plug in the Handset to the plug location "Y" on the control card. After installing the Handset tool, plug the battery in and turn the key switch on. The following is the
BDI Display or |
| Diagnostics Override | ||
Blank Display |
| |||
| With Fault | |||
(no BDI used) |
| |||
|
| |||
|
|
|
|
|
|
|
|
|
|
Run Mode
|
|
|
|
|
BDI Display or |
| Diagnostics Override | ||
Blank Display |
| |||
| With Fault | |||
(no BDI used) |
| |||
|
| |||
Key Switch
Off
Display Traction Hourmeter
For Four Seconds
Display Pump Hourmeter
For Four Seconds
NOTE: The vehicle can be operated with the Handset connected, however, the adjustment knob must be set fully clockwise to insure the control operates at top speed.
Warning: Before making any adjustments to the control, you must consult the operating and maintenance instructions supplied by the vehicle manufacturer. Failure to follow proper set up instructions could result in mis- operation or damage to the control system.
January 2000
