ADJUSTABLE FEATURES
SX TRANSISTOR CONTROLS | Page 56 |
Section 6.3 Set-up Function Procedures
With the Handset connected, hold down the CONT key and turn on the key switch. This will place you in the
NOTE: The term “Push” means to depress key for approximately one second.
Section 6.3.1 Setup Mode
SET-UP MODE
ACTION |
|
| DISPLAY |
|
| REMARKS |
|
| SHOWS |
|
| ||
|
|
|
|
|
| |
Hold Down CONT |
|
|
|
| Segment Check | |
| 8 8 8 8 | |||||
And Turn On Key |
|
|
| Displayed | ||
|
|
|
|
|
|
|
status codes will be overwritten each time a new status code occurs. This stored status code register can be cleared from memory by using the Handset.
ACCESSING STORED STATUS CODES
WITH GE HANDSET
Key Switch Off
Push ESC and CONT
At The Same Time
Release ESC and CONT
Key
Status Code Displayed
Push Function Number
After One Second
Time Delay
Push CONT
Change Value With Adjustment Knob
U 0 0 5
0 8 5
0 8 5
125
Selected Function No.
Is Displayed
Stored Value For The Function Is Displayed
Display Value
Will Blink
Value Changes
While Blinking
Push CONT Key
Displays Battery
Fault Occurred
Push CONT Key
|
|
|
| New Value Stored And |
Push STORE |
| 125 | ||
|
| Blinking Stops | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| Segment Check |
Push ESC | 8 8 8 8 |
| ||
| Displayed | |||
Display Hourmeter Reading When Fault Occurred
Push CONT Key
Push CONT Key
At this point, another function can be monitored/changed by pushing another function number, or the vehicle can be placed in the run mode by holding the ESC key down for one second or longer. The display will return to either the diagnostics mode, the BDI display, or a blank display (if BDI is not used and there are no fault codes). The vehicle can now be operated with the Handset connected, or the Handset can be disconnected before operation.
NOTE: You can return to the segment check mode at any time, by holding down the ESC key until 8888 appears in the display.
Section 6.3.2 Status Code Scrolling
The SX family of controllers furnishes a function register that contains the last 16 “stored status codes” that shut down vehicle operation (a PMT type fault that is reset by cycling the key switch) and the battery state of charge reading at the time the fault occurred. The first of the 16
Section 6.3.3 SX Family Handset, Plug
Connections and Outline Drawing
“Y” Plug
Handset Cable Part Number - 325B1002G1
January 2000
