GE IC3645SR4U404N2 Application, Standard Dash Displays, Connections, Reference

INSTALLATION AND OPERATION MANUAL
IT/IP TRANSISTOR CONTROL				Page 67
Section 7. DASH DISPLAYS		From the Dash Display, the operator may select any of four
		pre-set interactive modes consisting of (4) Controlled
Section 7.1 Application		Acceleration levels, (4) Field Weakening Pick Up levels and
		(4) Speed Limit levels.
The SX family Standard and Interactive Dash Displays		These interactive modes are “pre-set” using the Handset
allow the operator and maintenance personnel easy
access to truck operation information and real-time system		(Functions 48 - 63) or a personal computer (Functions 97 -
diagnostics of the controller, motor and various		112). This feature allows the operator to select the best
accessories. Hourmeter readings, battery discharge		vehicle performance for changing factory (task) conditions.
information, maintenance information and system status		The Custom Dash Display incorporates all the features and
codes are clearly displayed during startup and running
modes. Shielded cable connections are made to the Dash		functions of the Standard Dash Display, in addition to the
Display by means of five (5) 22-gage wires to the “Y” Plug		following customer options:
of the traction and hydraulic pump controls.		• LED graphics to display Battery Discharge Indication
Section 7.2 Standard Dash Displays		status.
		• Various LED indicators for Maintenance Required Status
		Codes. These can include options for traction, pump and
		power steer motors, hourmeter, over-temperature, seat
		belt, brake and other safety sensors.
g	GE Electric Vehicle	• A push-button associated with the four segment LED that
		displays Status Codes can be used to scroll the last 16
	Motors & Controls
		“Stored Status Codes” that shut down vehicle operation
		with a PMT fault.
		Connections
		Connections are made to the Dash Display with five (5) 22-
		gage wires to Plug "Y" of each control. Shielded cable is
+	-	required to eliminate signal interference.
		Part Number
		IC3645LXTDD	T	3
The GE Standard Dash Display is a four segment Light		T=Traction Only
Emitting Diode (LED) instrument that displays the GE LX, ZX,		P=Traction & Pump
and SX Status Codes, Hourmeter Readings, Battery
Discharge Indication, and Maintenance Required Code.		3=Round Face with four
The four LED's above the symbols indicate the active		display symbols
readout mode.
Section 7.3 Interactive Custom Dash Displays		For Custom Dash Displays,
		contact your vehicleOEM.

+			Reference
BATTERY			AMP#102241-3	Dash Display mating plug
	EVT100ZX	PUSH	AMP#1-87195-8	Dash Display mating pin
			44A723596-G09	Dash Display plug kit
-		PUSH	AMP#175965-2	"Y" Plug
			AMP#175180-1	"Y" Plug receptacle

The Interactive Custom Dash Display allows the operator to select the best vehicle performance for changing factory (task) conditions. There are four (4) “operator interaction modes” that can be selected by depressing a push-button on the dash display.

January 2001