
Overview of Navigation and Controls
•Delay: When detected motion is completed, the system will continue alarm output and recording for a specified time respectively. The value ranges from
•Region: Click Select, the interface is shown as in Figure
•Sensitivity: The system supports 6 levels. The sixth level has the highest sensitivity. The fifth or lower levels are recommended to avoid setting a false alarm.
•Show message: The system will send message to the local host screen to alarm you if you have enabled this function.
•Send email: The system can send out an email to alert you when the alarm occurs.
•PTZ activation: Here you can set PTZ movement (of any video channels) such as going to a preset when motion is detected in the current video channel. Click Select, and you can see an interface is shown as in Figure
•Period: Click Set to determine the period for the channel to be armed for motion detection. See the interface shown as in Figure
•Alarm output: After the motion detection has occurred, the system enables the peripheral alarm devices.
•Tour: Here you can enable the tour function when the alarm occurs. It is a
Note | If there are record channels selected, only the record | |
channels will be displayed in the tour. | ||
|
Check boxes to select the corresponding function. After all the settings, click Save, and the system will return to the previous menu.
In Figure
Note set a region for motion detection. Click Fn to switch between arm/withdraw motion detection. After setting the region, click the enter button to exit.
42