Honeywell K5305-1V5 Compatible Devices, Important Installation Highlights Installer Please Read

Installation and Setup Guide

Compatible Devices

Device	VISTA-20P	VISTA-15P	Notes
Addressable Keypads	8	8	6150 Fixed-Word Keypad, 6160 Alpha Keypad, 6150V
			Fixed-Word Display Voice Keypad, 6160V Alpha
			Display Voice Keypad, 6150RF Keypad/Transceiver
Touch Screen (AUI)	2	2	Touch Screen (AUI) devices are in addition to the 8
Devices			addressable keypads. E.g., Symphony, 6270
4219, 4229 Zone	Up to 5 for	Up to 2 for	Zone numbers are predefined according to the device
Expander Modules	up to 40	up to 16	addresses used. See Expander Module Addresses table
	exp. zones	exp. zones	in Wiring section and set addresses accordingly.
5800 Series Wireless	Up to 40 RF	Up to 26 RF	Uses 5881/5883 Series Receivers/Transceivers.
	zones	zones
Output relays and/or	Up to 16	Up to 8	Use any combination of 4204, 4229 and or Powerline
Powerline Carrier			Carrier Devices.
Devices (X-10 type)			Map output devices via *79 Menu mode.
On-Board Triggers	2	2	Can be used to reset 4-smoke detectors.
Output functions	Up to 48	Up to 24	Program output functions via *80 Menu mode.
4285/4286 Phone	Partition 1	yes	Provides access to the system via on premises or off-
Module	only		premises phones for arming, disarming, etc., plus
			control of relay outputs and Powerline Carrier devices.
Audio Alarm	Using AAV	Using AAV	Use ADEMCO UVS or Eagle Model 1250; can be used
Verification	module	module	in conjunction with an output trigger to permit voice
			dialog between an operator at the central station and
			a person at the premises.
Alarm output	12VDC, 2	12VDC, 2	Can drive the compatible sounders; steady output for
	AMP output	AMP output	burglary/panic, or temporal pulse (3 pulses – pause –
			3 pulses – pause – 3 pulses. . .) for fire. Uses current
			limiting circuitry for protection.
Auxiliary Power Output	See note.	See note	12VDC, 600 mA maximum; uses fuse for protection.
Backup Battery	See note.	See note.	Rechargeable (sealed lead-acid type) 12VDC, 4AH
			minimum.
Long Range Radio	See note.	See note.	Primary telephone number messages can be reported
			via ECP connection to various Long Range Radios
			(check compatibility/availability of specific models)
AC Power Supply	See note.	See note.	Plug-in 120VAC transformer, ADEMCO 1321
			(1321CN in Canada) or, if using Powerline Carrier
			devices, ADEMCO 1361X10 Transformer Module

NOTE: All devices and accessories used in a Canadian installation must be Listed for use in Canada.

Important Installation Highlights (Installer Please Read)

•This system uses addressable keypads and Zone Expander Modules (see Table of Addresses in Section 2. Mounting and Wiring – Wiring the Keypads and Other Addressable Devices).

•Keypads must be set for addresses 16-23 (first keypad is address 16, which is different from previous controls) and programmed in data fields *190-*196.

•Zone Expander Modules must be set for specific addresses (07-11), based on the zone numbers used.

•4204 Relay Modules must be set for specific addresses (12-15).

•This control will not power-up unless AC power is connected (will not power-up on battery alone). However, once the system is powered up, it will operate on battery power in the event of AC loss.

•Relays have two programming menu modes: Use *79 Menu mode to map module addresses and device (output) numbers. Use *80 Menu mode to define the output functions.

•This system supports programmable function keys. Use *57 Menu mode to define the function keys.

•This system provides various paging features. Refer to the Programming Overview section for a summary on pager programming.

1-2