Honeywell K5305-1V5 Zone Type Definitions, Installation and Setup Guide, Description, Entry/Exit

To Initialize Download ID

Installation and Setup Guide

Interactive Mode Programming (∗56, *57, ∗58, ∗79, ∗80, ∗81, ∗82)

Entering Interactive Mode Press [∗] + [Interactive Mode No.] (for example, ∗56) while in Program Mode. The Alpha

display keypad will display the first of a series of prompts.

After making the appropriate entry, press the [∗] key to accept the entry and continue to the next prompt.

Loading Factory Defaults/Initializing for Download

To Load Default Entries Press ∗97 while in Program Mode. This resets all data fields to the default values shown on the Program Form. Use ∗97 only if you wish to return to the original factory- programmed defaults.

Press ∗96 while in Program Mode. This initializes the system for downloading and resets all the subscriber account numbers and CSID.

Do not press ✱97 to load defaults if any programming has been done previously—data already programmed into the system will be changed!

Exiting the Programming Mode

Prevent installer code	Press ∗98. Exits Programming Mode and prevents re-entry by:
reentry	Installer Code + [8] + [0] + [0]. To enter the programming mode if ∗ 98 was used to exit,
	you must first power the system down. Then power up again, and press [∗] and [#] at the
	same time, within 50 seconds of powering up.
	See field *88 for other Program mode lockout options.
Allow installer code	Press ∗99. Exits Programming Mode and allows re-entry by:
reentry	Installer Code + [ 8] + [0] + [0] or by: Pressing [∗] and [#] at the same time, within 50
	seconds of power-up.

Zone Type Definitions

Zone types define the way in which the system responds to faults in each zone.

Zone Type	Description
Type 00	Program a zone with this zone type if the zone is not used.
Zone Not Used
Type 01	• Assign to zones that are used for primary entry and exit.
Entry/Exit	• Provides entry delay when zone is faulted if control is armed in the Away, Stay, or Night-Stay
Burglary #1	modes.
	• No entry delay provided when the panel is armed in the Instant/Maximum mode.
	• Entry delay #1 is programmable for each partition (field *35).
	• Exit delay begins whenever the control is armed, regardless of the arming mode selected, and
	is programmable (field ✱34).
Type 02	• Assign to zones that are used for entry and exit and require more time than the primary
Entry/Exit	entry/exit point.
Burglary #2	• Provides a secondary entry delay, in same manner as entry delay #1.
	• Entry delay #2 is programmable for each partition (field *36).
	• Exit delay is same as described for Type 01.
Type 03	• Assign to all sensors or contacts on exterior doors and windows.
Perimeter	• Provides an instant alarm if the zone is faulted when the panel is armed in the Away, Stay,
Burglary	Night-Stay, Instant or Maximum modes.
Type 04	• Assign to a zone covering an area such as a foyer, lobby, or hallway through which one must
Interior Follower	pass upon entry (to and from the keypad).
	• Provides a delayed alarm (using the programmed entry 1 time) if the entry/exit zone is faulted
	first. Otherwise this zone type gives an instant alarm.
	• Active when the panel is armed in the Away mode.
	• Bypassed automatically when the panel is armed in the Stay or Instant modes;
	if armed in Night-Stay mode, zones assigned to zone list 05 (night-stay zone list) are not
	bypassed when system armed in Night-Stay mode.

3-2