1

2

3

4

5

6

Loading optional tray 3

The optional tray 3 supports A4- and letter-size paper. Optional tray 3 supports only paper, but paper includes average-weight letterhead and prepunched paper.

For additional information about letterhead and prepunched paper, see “Printing on letterhead or preprinted forms” on page 47.

CAUTION

Print special print media such as labels and grayscale transparencies from tray 1 only. Printing special print media from optional tray 2 or optional tray 3 can cause jams.

To load optional tray 3

1Pull the tray out of the printer and remove any paper.

2For letter-size paper, pull the rear stop up. For A4-size paper, push the rear stop down.

3For letter-size paper, move the side width guides outward as far as possible. For A4-size paper, move the side width guides inward as far as possible.

4Load the paper. If this is special paper such as letterhead, load it with the side to be printed down and the top edge toward the front of the tray.

Note

If you are manually duplexing, see “Printing on both sides (duplexing manually)” on page 48 for loading instructions.

5Make sure the stack of paper is flat in the tray at all four corners, and keep it below the height tabs on the length guide in the rear of the tray.

6Slide the tray back into the printer.

EN

Chapter 2 Printing tasks 33