Installing an HP Jetdirect print server card
1 | You can install an optional HP Jetdirect print server card in the 2500L or | |
2500 model printer, which comes with an EIO slot. | ||
| To install an HP Jetdirect print server card | |
| 1 | Turn the printer off and disconnect the power cable and the parallel |
|
| or USB (interface) cable. |
| 2 | Locate the EIO slot. Loosen and remove the two retaining screws |
2 |
| holding the cover for the EIO slot onto the printer, and then remove |
| the cover. |
3Firmly insert the HP Jetdirect print server card into the EIO slot.
Insert and tighten the retaining screws that came with the print server card.
4Connect the network cable.
5Reconnect the power cable, and turn the printer on.
3 | 6 Print a Configuration page at the printer by pressing | (GO) and |
| (CANCEL JOB) simultaneously. In addition to a printer |
|
| Configuration page and a Supplies Status page, an HP Jetdirect | |
| configuration page should print. If it does not print, uninstall and | |
| reinstall the print server card to ensure that it is completely seated | |
| in the slot. |
|
4 | Note |
| |
If the configuration page does not print in your language, see “Special | |||
| pages” on page 56. | ||
| 7 Perform one of these steps: | ||
4 | Choose the correct port. See the computer or operating system | ||
documentation for instructions. | |||
| |||
5 | Reinstall the software, choosing the network installation this | ||
time. | |||
|
|
EN | Appendix D Working with memory and print server cards 139 |