HP 377707-002 Out Part Enforce, Filter Raw Packet Enforce, Out Filter Raw Packet, Guid Cap

	55
Table 5-9:Topology Port Properties Window Fields (Continued)
Field	Description
In Part Enforce	Boolean value that indicates whether or not to support optional
	partition enforcement for the packets received by this port.
	There is no default value.
Out Part Enforce	Boolean value that indicates whether or not to support optional
	partition enforcement for the packets transmitted by this port.
	There is no default value.
In Filter Raw Packet Enforce	Boolean value that indicates whether or not to support optional
	raw packet enforcement for the raw packets received by this
	port. There is no default value.
Out Filter Raw Packet	Boolean value that indicates whether or not to support optional
Enforce	raw packet enforcement for the raw packets transmitted by this
	port. There is no default value.
MKey Violation	Number of subnet management packets (SMPs) that have been
	received on this port with invalid M_Keys since initial powerup
	or the last reset. Refer to section 14.2.4, Management Key,
	“InfiniBand® Architecture, Vol. 1, Release 1.0”, for more
	information.
PKey Violation	Number of SMPs that have been received on this port with
	invalid P_Keys since initial powerup or the last reset. Refer to
	section 9.2.7, partition key (P_KEY), “InfiniBand®
	Architecture, Vol. 1, Release 1.0”, for more information.
QKey Violation	Number of SMPs that have been received on this port with
	invalid Q_Keys since initial powerup or the last reset. Refer to
	section 10.2.4, Q Keys, “InfiniBand® Architecture, Vol. 1,
	Release 1.0”, for more information.
GUID Cap	Number of GUID entries allowed for this port in the port table.
	Any entries that exceed this value are ignored on write and read
	back as zero. Refer to section 14.2.5.5, GUIDCap,
	“InfiniBand® Architecture, Vol. 1, Release 1.0”, for more
	information.
Subnet Timeout	Maximum propagation delay allowed for this port to reach any
	other port in the subnet. This value also affects the maximum
	rate at which traps can be sent from this port. Delay is affected
	by switch configuration. This parameter, along with resp-time,
	may be used by requestors to determine the interval to wait for a
	response to a request before taking other action. Duration is
	calculated as (4.096 ms * 2^SubnetTimeout).
Response Time	Maximum time allowed between the port reception of a subnet
	management packet and the transmission of the associated
	response. Refer to section 13.4.6.2, Timers and Timeouts,
	“InfiniBand® Architecture, Vol. 1, Release 1.0”, for more
	information.
Local Physical Error	Threshold at which ICRC, VCRC, FCCRC, and all physical
	errors result in an entry into the BAD PACKET or BAD
	PACKET DISCARD states of the local packet receiver. Refer to
	section 7.12.2, Error Recovery Procedures, “InfiniBand®
	Architecture, Vol. 1, Release 1.0”, for more information.