Internal control-panel cable

1.Remove the following items:

●Flatbed unit. See Flatbed scanner assembly on page 96.

●Upper flatbed ribbon guide. See Power supply on page 99 (steps 2 and 3).

2.Use needle-nose pliers to disconnect one connector (callout 1) and unclip three wire clips (callout 2).

1

2

3

Figure 5-98Removing the internal control-panel cable (1 of 2)

3.Disconnect the internal control-panel cable from the left side of the interconnect board (callout 3).

3

Figure 5-99Removing the internal control-panel cable (2 of 2)

110 Chapter 5 Removal and replacement

ENWW