ADF mylar shield

1.Remove the mylar-holder assembly. See Mylar-holder assembly on page 44.

2.Carefully unhook the mylar shield from the four tabs on the mylar-holder assembly, and then remove and discard the mylar shield.

Figure 5-13Replacing the ADF mylar shield (4 of 7)

3.Use a dry cloth to clean the white strips inside of the mylar-holder assembly.

4.Insert a new mylar shield, and clip it onto the four tabs on the mylar-holder assembly. NOTE: Make sure that you do not leave fingerprints on the new mylar shield.

Figure 5-14Replacing the ADF mylar shield (5 of 7)

46 Chapter 5 Removal and replacement

ENWW