Power plug

1.Remove the flatbed unit. See Flatbed scanner assembly on page 96.

2.Remove one grounding screw and wire (callout 1), unclip four wire clips (callout 2), and disconnect one connector (callout 3).

NOTE: You might have to cut a zip tie in order to release the wires.

1

2

3

Figure 5-95Removing the power plug (1 of 2)

3.Using a pair of pliers, depress the two tabs and remove the power plug through the hole.

Figure 5-96Removing the power plug (2 of 2)

108 Chapter 5 Removal and replacement

ENWW