To connect the HP All-in-One to the network

1.Remove the yellow plug from the back of the HP All-in-One.

2.Connect the Ethernet cable to the Ethernet port on the back of the HP All-in-One.

3.Connect the other end of the Ethernet cable to an available port on your Ethernet router or switch.

4.Once you have connected the HP All-in-One to the network, install the software.

Install the software for a network connection

Use this section to install the HP All-in-One software on a computer connected to a network. Before you install the software, make sure you have connected the HP All-in- One to a network.

Note 1 If your computer is configured to connect to a series of network drives, make sure that your computer is currently connected to these drives before installing the software. Otherwise, HP All-in-One installation software might try to use one of the reserved drive letters, and you will not be able to access that network drive on your computer.

Network setup

Basics Guide

11

Page 14
Image 14
HP C6180, C6150 manual Install the software for a network connection, To connect the HP All-in-One to the network