(continued)

Parameter

Description

 

 

 

Note You will need to know this URL when you try to access the

 

Embedded Web Server.

 

 

Firmware

The internal networking component and device firmware revision

Revision

code.

 

Note If you call HP Support, depending on the problem, you might

 

be asked to provide the firmware revision code.

 

 

Hostname

The TCP/IP name assigned by the installation software to the device.

 

By default, this is the letters HP followed by the last 6 digits of the

 

Media Access Control (MAC) address.

 

 

Admin

Status of the administrator's password for the Embedded Web

Password

Server:

 

Set: Password is specified. You must enter the password to

 

make changes to the Embedded Web Server parameters.

 

Not Set: No password is set. A password is not required for

 

making changes to the Embedded Web Server parameters.

 

 

mDNS

Some local and ad hoc networks do not use central DNS servers.

 

They use a DNS alternative called mDNS.

 

With mDNS, your computer can find and use any HP All-in-One

 

connected to your local area network. It can also work with any other

 

Ethernet-enabled device that appears on the network.

 

 

Wired (802.3) network settings

The following table describes the 802.3 wired settings shown on the network configuration page.

Network setup

Parameter

Hardware Address (MAC)

IP Address

Description

The Media Access Control (MAC) address that identifies the HP All- in-One. This is a unique 12-digit identification number assigned to networking hardware for identification, including routers, switches, and other such devices. No two pieces of hardware have the same MAC address.

Note Some Internet service providers (ISPs) require that you register the MAC address of the Network Card or LAN Adapter that was connected to your cable or DSL modem during installation.

This address uniquely identifies the device on the network. IP addresses are assigned dynamically through DHCP or AutoIP. You can also set up a static IP address, though this is not recommended.

Caution Be careful when manually assigning an IP address. An invalid IP address during installation will prevent your network components from seeing the HP All-in-One.

Basics Guide

27

Page 30
Image 30
HP C6180, C6150 manual Wired 802.3 network settings, Parameter