Solution Try reinserting the cables. Or, if necessary, try a different cable.

Cause The HP All-in-One is assigned an AutoIP address instead of DHCP.

Solution This indicates that the HP All-in-One is not connected properly to the network. Check the following:

●Make sure all cables are connected properly and securely.

●If the cables are connected properly, your access point, router, or home gateway might not be sending an address. If this is the case, you might need to reset the device.

●Make sure the HP All-in-One is on the correct network.

Cause The HP All-in-One is on the wrong subnet or gateway.

Solution Print a network configuration page, and verify that the router and HP All-in-One are on the same subnet and gateway.

To print the network configuration page

1.On the control panel of the HP All-in-One, press Setup.

2.Press until Network is highlighted, and then press OK.

3.Press until View Network Settings is highlighted, and then press OK.

4.Press until Print Network Configuration Page is highlighted, and then press OK. This prints the network configuration page.

I am using a cable modem without a router and I do not have IP addresses

Cause If you have a computer with a cable modem, a separate Local Area Network (LAN) for your other computers, and no DHCP or router, you must use AutoIP to assign IP addresses to the other computers and to the HP All-in-One.

Solution

To obtain an IP address for the computer with the cable modem

➔Your Internet Service Provider (ISP) assigns either a static or dynamic IP address to the computer with the cable modem.

To assign IP addresses to the remaining computers and the HP All-in-One

➔Use AutoIP to assign IP addresses to the remaining computers and the HP All-in-One. Do not assign a static IP address.

Wireless setup troubleshooting

This section addresses problems you might encounter setting up a network. Check the device display for specific error messages.

●You do not see the SSID

●Weak signal

●Error message: Cannot connect to network

●Error message: Cannot connect to network. Unsupported authentication or encryption type

●Error message: Invalid WEP Key

●Error message: Invalid passphrase

●Error message: The access point timed out before a connection could be made

●Error message: More than 1 SecureEZ Setup access point found

●Error message: Another device connected to the access point before your device tried connecting

You do not see the SSID

Cause Your access point is not broadcasting its network name (SSID) because the Broadcast SSID option is turned off..

support and Troubleshooting

Basics Guide

95