Chapter 14

Troubleshooting

To check the USB connection

1.Verify that the USB cable is securely plugged into the USB port on the back of the product.

2.Make sure the other end of the USB cable is plugged into a USB port on your computer.

3.Try to scan again.

If the scan fails, continue to the next step.

4.Do one of the following, depending upon how the product is connected to the computer:

If the USB cable is connected to a USB hub, try unplugging and replugging the USB cable into the hub. If that does not work, try turning off the hub and then turning it on again. Finally, try disconnecting the cable from the hub and connecting it directly to the computer.

If the USB cable is connected to a docking station for a laptop, disconnect the cable from the docking station and connect it directly to the computer.

If the USB cable is directly connected to the computer, try plugging it into another USB port on the computer.

5.If there are other USB devices connected to the computer, disconnect the other devices, except for the keyboard and the mouse.

6.Check the USB cable to make sure it is functioning properly.

NOTE: If you are using an older cable, it might not be working properly. Try connecting it to another product to see if the USB cable works. If you experience problems, the USB cable might need to be replaced. Also verify that the cable does not exceed 3 meters (9.8 feet) in length.

7.If another USB cable is available, try using that one instead.

8.Restart the computer.

9.After the computer restarts, try to scan again.

Cause: The product was not properly connected to the computer. If this did not solve the issue, try the next solution.

234 Troubleshooting

Page 237
Image 237
HP C6340, C6380 manual To check the USB connection